Guide
Diy macbook air battery replacement: save money and extend your laptop’s life
What To Know
- Use the suction cup to lift up the bottom case and separate it from the rest of the MacBook Air.
- If you are replacing the battery in an older MacBook Air, you may need to use a heat gun to soften the adhesive strips that hold the battery in place.
- Replacing the battery in your MacBook Air is a relatively simple task that can be completed in just a few hours.
Replacing the battery in your MacBook Air can be a daunting task, but it’s a lot easier than you might think. With the right tools and instructions, you can do it yourself in just a few hours.
Tools and Materials
Before you start, you’ll need to gather the following tools and materials:
- A new MacBook Air battery
- A Phillips #00 screwdriver
- A spudger
- A suction cup
- A heat gun (optional)
Safety Precautions
Before you begin, it’s important to take some safety precautions:
- Power down your MacBook Air and unplug it from the power outlet.
- Discharge the battery by holding down the power button for 10 seconds.
- Wear anti-static gloves to prevent electrostatic discharge.
Step-by-Step Instructions
1. Remove the Bottom Case
- Close the display and place the MacBook Air upside down on a flat surface.
- Use the Phillips #00 screwdriver to remove the 10 screws that secure the bottom case.
- Use the suction cup to lift up the bottom case and separate it from the rest of the MacBook Air.
2. Disconnect the Battery
- Locate the battery connector on the logic board.
- Use the spudger to gently pry up the battery connector and disconnect it from the logic board.
3. Remove the Battery
- Use the spudger to carefully pry up the battery from the adhesive strips that hold it in place.
- Be careful not to damage the battery or the logic board.
4. Install the New Battery
- Align the new battery with the battery compartment.
- Press down on the battery to secure it in place.
- Connect the battery connector to the logic board.
5. Reattach the Bottom Case
- Align the bottom case with the MacBook Air and press down to secure it.
- Use the Phillips #00 screwdriver to tighten the 10 screws.
6. Calibrate the Battery
- Plug in your MacBook Air and turn it on.
- Allow the battery to charge to 100%.
- Unplug the MacBook Air and let the battery drain to 0%.
- Repeat this process 2-3 times to calibrate the battery.
Troubleshooting
- My MacBook Air won’t turn on after replacing the battery. Make sure that the battery is properly connected to the logic board and that the bottom case is securely attached.
- My battery is not charging. Check the battery connector to make sure that it is properly connected. You can also try using a different charger.
- My battery is draining too quickly. Calibrate the battery as described above. If the problem persists, the battery may be defective.
Tips
- If you are not comfortable replacing the battery yourself, you can take your MacBook Air to an Apple Store or authorized service provider.
- If you are replacing the battery in an older MacBook Air, you may need to use a heat gun to soften the adhesive strips that hold the battery in place.
- Be careful not to damage the logic board or the battery when removing or installing the battery.
Wrapping Up
Replacing the battery in your MacBook Air is a relatively simple task that can be completed in just a few hours. By following these instructions, you can save yourself the cost of a professional repair.